How to Filter Reports

Filters can be applied to reports by following the below steps: 

Go to the 'Reports' section > Select the report that you would like to run. In this example, we are going to run the 'Patient' Report'. See below:

This will bring back all patients within the practice.

Reports can then be filtered even more if required. All reports in Aerona can be filtered by following the below steps:

- Select the +/- icon to the top left-hand corner of the table.

- Use the drop-down boxes located under each column to filter the columns to the desired criteria that you wish. 

- Once you are happy to apply the filters select the magnifying button located to the left-hand side of the table.

(See below)

The report will then bring back all results that are applicable when the filters are applied. See below: